Open Research Newcastle
Browse

Dry separation using a fluidized Sink-Hole

Download (1.58 MB)
journal contribution
posted on 2025-05-09, 15:13 authored by D. Kumar, Simon IvesonSimon Iveson, Kevin GalvinKevin Galvin
Dry separation of heavy-mineral particles such as iron ore in the nominal size range of 1-10 mm is a significant challenge. This paper reports the findings of dry separation experiments conducted under batch conditions using a novel device referred to as the Sink-Hole fluidizer. The device utilizes a fluidized bed, with vibration applied as an additional energy source to disrupt the tendency of the excess air to pass through as bubbles. The fluidized bed is covered by a fine mesh containing holes with a nominal 1 mm square aperture. A much larger hole located at the centre acts as the "Sink-Hole". When the system is fluidized the media expands, passing up through the Sink-Hole, spilling onto the adjacent mesh, and sifting back into the lower bed. For this work nominal 200 μm sand was used as the bed media. Tracer particles of density 2.4 to 4.8 RD, covering the size range from 2.0 to 8.0 mm, were added onto the mesh. The vibration caused the particles to repeatedly pass over the Sink-Hole, resulting in some sinking through the media, and others remaining on the mesh. By adjusting the mass of sand in the system and the superficial air velocity, it was possible to vary the separation density from 2.5 to 3.2 RD, whilst holding the Ep values in the range 0.1 to 0.2 RD.

Funding

ARC

IH130200031

History

Journal title

Minerals Engineering

Volume

127

Pagination

105-113

Publisher

Elsevier

Language

  • en, English

College/Research Centre

Faculty of Engineering and Built Environment

School

School of Engineering

Rights statement

©2019. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/

Usage metrics

    Publications

    Exports

    RefWorks
    BibTeX
    Ref. manager
    Endnote
    DataCite
    NLM
    DC